Dell PowerVault MD3620f Command Line Interface Manual page 178

Parameters
Parameter
sourceVirtualDisk
repositoryRAIDLevel
repositoryPhysicalDisks
repositoryDriveCount
repositoryDiskGroupUserLabel
repositoryDiskGroup
userLabel
enclosureLossProtect
178
Script Commands
Description
Name of the source virtual disk from
which to take a snapshot. You must put
quotation marks (" ") around the source
virtual disk name.
RAID level for the repository virtual disk.
Valid values are 0, 1, 5, or 6.
Specifies the physical disks to assign to
the repository. Specify the enclosure ID
and slot ID for each physical disk assigned
to the virtual disk. Enclosure ID values
are 0 to 99. Slot ID values are 0 to 31. You
must put parentheses around the list of
repository physical disks.
Number of unassigned physical disks to
use for the repository virtual disk.
Use this parameter when you create a new
disk group.
The name of a new disk group to be used
for the repository virtual disk. Enclose the
repository disk group name in double
quotation marks (" ").
Sequence number of the disk group where
the repository virtual disk is located.
The name to give the snapshot virtual
disk. You must put quotation marks (" ")
around the snapshot virtual disk name.
Specifies that enclosure loss protection is
enforced when creating the repository. To
enforce enclosure loss protection, set this
parameter to TRUE. The default setting
is FALSE. For information about the
enclosureLossProtect parameter, see
"Enclosure Loss Protection" on page 54.