Replace Physical Disk
This command redefines the composition of a disk group by replacing a
physical disk that is in the disk group with either:
•
An unassigned physical disk
•
A fully integrated hot spare physical disk
Syntax
replace physicalDisk ([enclosureID,slotID] |
<wwID>)
replacementPhysicalDisk=enclosureID,slotID
Parameters
Parameter
physicalDisk
physicalDisk <wwID>
replacementPhysicalDisk
Description
Specifies the physical disks to assign to
the virtual disk that you want to create.
Specify the enclosure ID and slot ID for
each physical disk that you assign to the
virtual disk. Enclosure ID values are 0 to
99. Slot ID values are 0 to 31. You must
put brackets ([ ]) around the enclosure ID
value and the slot ID value.
The World Wide Identifier (WWID) of
the physical disk that you want to replace.
You can use the WWID instead of the
virtual disk name to identify the virtual
disk. Enclose the WWID in angle
brackets (< >).
Specifies the physical disks to assign to
the virtual disk that you want to create.
Specify the enclosure ID and slot ID for
each physical disk that you assign to the
virtual disk. Enclosure ID values are 0 to
99. Slot ID values are 0 to 31.
Script Commands
213