Dell PowerVault MD3620f Command Line Interface Manual page 203

Parameters
Parameter
target
source
copyPriority
targetReadOnlyEnabled
Description
Name of the target virtual disk for which to
reinitiate a virtual disk copy operation. You must
put brackets ([ ]) around the target virtual disk
name. If the target virtual disk name has special
characters, you must also put quotation marks (" ")
around the target virtual disk name.
Name of the source virtual disk for which to
reinitiate a virtual disk copy operation. You must
put brackets ([ ]) around the source virtual disk
name. If the source virtual disk name has special
characters, you must also put quotation marks (" ")
around the source virtual disk name.
Specifies the priority that the virtual disk copy has
relative to host I/O activity. Valid entries are highest,
high, medium, low, or lowest.
NOTE:
CopyPriority defines the amount of system
resources used to copy the data between the source
and target virtual disks of a virtual disk copy pair. If
you select the highest priority level, the virtual disk
copy uses the most system resources to perform
virtual disk copy, which decreases performance for
host data transfers.
Specifies whether the target virtual disk is write
enabled or read only. To be able to write to the
target virtual disk, set this parameter to FALSE. To
prevent writing to the target virtual disk, set this
parameter to TRUE.
Script Commands
203