Set Virtual Disk Copy - Dell PowerVault MD3620f Command Line Interface Manual

Set Virtual Disk Copy

This command defines the properties for a virtual disk copy pair.
Syntax
set virtualDiskCopy target [targetName] [source
[sourceName]] copyPriority=(highest | high |
medium | low | lowest) targetReadOnlyEnabled=(TRUE
| FALSE)
Parameters
Parameter
target
source
copyPriority
targetReadOnlyEnabled Specifies whether the target virtual disk is write
NOTE:
When using this command, you can specify one or more of the parameters.
You do not, however, need to use all of the parameters.
268
Script Commands
Description
Specifies the name of the target virtual disk for which
to define properties. You must put brackets ([ ])
around the target virtual disk name. If the target
virtual disk name has special characters, you must also
put quotation marks (" ") around the target virtual
disk name.
Specifies the name of the source virtual disk for which
to define properties. You must put brackets ([ ])
around the source virtual disk name. If the source
virtual disk name has special characters, you must also
put quotation marks (" ") around the source virtual
disk name.
Specifies the priority that the virtual disk copy has
relative to host I/O activity. Valid entries are highest,
high, medium, low, or lowest.
enabled or read only. To be able to write to the target
virtual disk, set to FALSE. To prevent writing to the
target virtual disk, set to TRUE.