Start Enclosure Blink
This command identifies an enclosure by turning on the indicator LED. (Use
the stop enclosure blink command to turn off the indicator LED for the
enclosure.)
Syntax
start enclosure [enclosureID] blink
Parameter
Parameter
enclosure
Start iSCSI DHCP Refresh
This command initiates a refresh of the DHCP parameters for the iSCSI
interface. If the configuration method for the interface is not set to DHCP ,
the procedure returns an error.
Syntax
start controller [(0 | 1)] iscsiHostPort [(1 | 2 |
3 | 4)] dhcpRefresh
Parameters
Parameter
Description
controller The identifier letter of the RAID controller module that has the
iSCSI host ports. Valid RAID controller module identifier values are
0 or 1, where, 0 is the RAID controller module in slot 0, and 1 is the
RAID controller module in slot 1.
The identifier of the port on the storage array on which you want to
iscsi-
refresh the DHCP parameters. Enclose the iSCSI host port name in
host-port
square brackets
NOTE:
This operation ends the iSCSI connections for the portal and brings down
the portal temporarily.
Description
Identifies the enclosure to blink. Enclosure ID
values are 0 to 99. You must put brackets ([ ])
around the enclosure ID value.
([ ]).
Script Commands
297