Dell PowerVault MD3620f Command Line Interface Manual page 267

Parameter
accessVirtualDisk
logicalUnitNumber
host
hostGroup
NOTE:
When using this command, you can specify one or more of the parameters.
You do not, however, need to use all of the parameters.
NOTE:
You can apply the
logicalUnitNumber
NOTE:
Setting the
starts a long-running operation that you cannot stop. These long-running
operations are performed in the background and do not prevent you from running
other commands. To display the progress of long-running operations, use the show
virtualDisk actionProgress command.
Description
Specifies the logical unit number for the
access virtual disk. The logical unit number is
the only property that you can set for the access
virtual disk.
NOTE:
parameter, the only property that you can set is
the
Defines specific virtual disk-to-LUN mappings
to an individual host or assigns the host to a
host group.
Specifies the name of the host to which the
virtual disk is mapped. You must put
quotation marks (" ") around the host name.
Specifies the name of the host group to which
the virtual disk is mapped. You must put
quotation marks (" ") around the host group
name.
addCapacity
parameters to only one virtual disk at a time.
addCapacity addPhysicalDisks
,
If you specify the
logicalUnitNumber
.
segmentSize userLabel
, ,
segmentSize
, or
Script Commands
accessVirtualDisk
, and
parameter
267