Dell PowerVault MD3620f Command Line Interface Manual page 266

Parameter
addPhysicalDisks
consistencyCheckEnabled
segmentSize
userLabel
preReadRedundancyCheck
266
Script Commands
Description
Adds new physical disks to the virtual disk.
Specify the enclosure ID and slot ID for each
physical disk that you assign to the virtual
disk. Enclosure ID values are 0 to 99. Slot ID
values are 0 to 31. You must put brackets ([ ])
around the enclosure ID values and the slot
ID values. Use with the addCapacity
parameter if you must specify additional
physical disks to accommodate the new size.
Turns consistency checking during a media
scan on or off. To turn consistency checking
on, set to TRUE. To turn consistency
checking off, set to FALSE.
Amount of data (in kilobytes) that the RAID
controller module writes on a single physical
disk in a virtual disk before writing data on the
next physical disk. Valid values are 8, 16, 32,
64, 128, 256, or 512. For information about
the segmentSize parameter, see "Using the
Auto Configure Command" on page 54.
Specifies the new name to give an existing
virtual disk. You must put quotation marks
(" ") around the new virtual disk name.
The setting to check the consistency of RAID
redundancy data on the stripes during read
operations. Do not use this operation for
nonredundant virtual disks, for example RAID
Level 0. To check redundancy consistency, set
this parameter to TRUE. For no stripe
checking, set this parameter to FALSE.