Dell PowerVault MD3620f Command Line Interface Manual page 155

Parameter
driveMediaType
physicalDiskType
capacity
owner
Description
The type of physical disk media that you want to use
for the disk group. Valid physical disk media consists
of:
• HDD — Use this option when you have hard
physical disks in the expansion enclosure.
• SSD — Use this option when you have solid state
physical disks in the expansion enclosure.
• unknown —Use if you are not sure what types of
physical disk media are in the expansion enclosure.
• allMedia — Use this option when you want to use
all types of physical disk media that are in the
expansion enclosure.
The type of physical disk that you want to use in the
virtual disk. You cannot mix physical disk types. The
valid physical disk type is SAS. You must specify a
physical disk type.
The size of the virtual disk that you are adding to
the storage array. Size is defined in units of bytes,
KB, MB, GB, or TB. The following examples show
the syntax:
capacity=500 bytes
capacity=2 GB
NOTE:
A space must be added between the last digit
and the size (bytes, KB, MB, or GB) for values greater
than 9.If you do not specify a capacity, all the available
physical disk capacity in the disk group is used. If you
do not specify the capacity unit, bytes is used as the
default unit.
The setting for which RAID controller module owns
the disk group. Valid RAID controller module
identifiers are 0 or 1, where, 0 is the RAID controller
module in slot 0, and 1 is the RAID controller
module in slot1. If you do not specify an owner, the
RAID controller module firmware determines the
owner.
Script Commands
155