Pulse To Tone Conversion - NEC DSX Software Manual

Pulse to Tone Conversion

Description
Use special services (such as telephone banking) over dial pulse lines.
An extension can use Pulse to Tone Conversion while placing an outside call to change the dialing mode
from dial pulse to DTMF. For a system in a dial pulse area, this permits users to access DTMF services (such
as telephone banking) from their DP area. Pulse to tone conversion also helps dial pulse callers use another
company's automated attendant dialing options. The user can, for example:
Place a call to their bank over a DP line.
❥
After the banking service answers, wait 6 seconds. (The system automatically converts dialing to DTMF.)
❥
Dial additional banking options.
❥
Refer to Central Office Calls, Answering (page 74) and Central Office Calls, Placing (page 78) for the spe-
cifics on setting up your outside calling.
Conditions
• None
Default Setting
• Pulse to Tone Conversion always enabled for dial pulse lines.
Programming
1. Set up your dial pulse lines.
1. In 3101-01: Line Type (page 809) enter the connected line's type.
In 3101-03: DTMF Dialing (page 811), enter
2.
Other Related Features
Features
Single Line Telephones (page 305)
The system does not provide Pulse to Tone Conversion for SLTs. The conversion must be switched
manually from the telephone.
Speed Dial (page 315)
If a Speed Dial number using a dial pulse line contains a pause, the digits following the pause auto-
matically dial out as DTMF.
IntraMail Features
None
Operation
To convert your telephone's dialing to DTMF after placing your call on a DP line:
Dial the initial digits for the call.
1.
2. Wait six seconds.
Dial additional digits.
3.
• The additional digits dial out as DTMF.
DSX Software Manual
Converting Dialing from DP to DTMF
Pulse to Tone Conversion
.
0
In these instructions:
[Super Display Soft Key]
[Keyset Soft Key]
Features ◆ 285