Tie Lines - NEC DSX Software Manual

Tie Lines

Tie Lines
Description
In DSX-80/160, link two systems together for inter-system Intercom calling and other features.
Tie lines directly link a local DSX-80/160 telephone system with one or more remote DSX-80/160 systems.
The link is independent of the telco's switched network. When a local system user seizes a tie line, they hear
Intercom dial tone from the remote system. The user can then use many of the features normally available to
the remote system's single line telephones, including:
Dialing Intercom extensions in the remote system.
❥
Using the remote system's lines for outgoing calls.
❥
Accessing System Speed Dial bins in the remote system.
❥
Using the remote system's Paging.
❥
Tie Lines require a T1 PCB and Tie Line service from the telco.
Conditions
• None
Default Setting
• Disabled
Programming
1. Set the circuit type for each tie line.
1. Be sure your T1PCB is installed and connected, and that your telco is providing T1 tie line service.
2. In 3101-01: Line Type (page 809), enter the correct circuit type for each T1 tie line.
- 05 for E&M Wink Start
- 06 for E&M Immediate Start
3. In 3101-03: DTMF Dialing (page 811), indicate whether the line is DTMF ( 1 ) or Dial Pulse ( 0 ).
2. Assign the tie line caller's operator.
1. In 3141-02: Tie Line Caller's Operator Extension (page 830), assign the tie line's operator extension.
- This is the extension reached when the incoming tie line caller dials 0.
3. Assign the outbound Line Group reached when an incoming tie line caller dials 9.
1. In 3141-01: Tie Line Caller's Outbound Dial 9 Group (page 830), assign the Line Group reached (90-98)
when incoming tie line callers dial 9 to place an outgoing call.
2. In 3142-[01-64]: Tie Line Caller's Outbound Line Access (page 831), assign access for each line incom-
ing tie line callers can use for placing an outgoing calls.
- 0 for no access
- 1 for incoming only access
- 2 for outgoing only access
- 3 for full access
In 3143-[01-64]: Tie Line Caller's Outbound Line Group Access (page 832), enter Yes for each Line
3.
Group incoming tie line callers can use for placing outgoing calls.
- You can deny outgoing access to individual lines within the group in step 2 above.
344 ◆ Features
DSX Software Manual