Programming A Memory Channel Via The Microphone - Icom IC-2100H Instruction Manual

6
MEMORY OPERATION

Programming a memory channel via the microphone

The microphone can also be used to program
MW
memory channels.
Ä Set the desired frequency in VFO mode:
Push [VFO] to select VFO mode.
Set the frequency using the keypad.
Set other data (e.g. offset frequency, duplex direction,
subaudible tone encoder ON/OFF and its frequency), if
necessary.
[EXAMPLE]: Programming 145.870 MHz into memory channel 20 via the microphone.
Push
VFO
Push
X
28
1
4 5
MONI
HIGH MID
C
ENT
8
7 0
DUP+
DUP
5 9
1
MW
then
Push
FUNC A
CLR
5 9
1
M
Å Push [FUNC], then [EMW] momentarily.
Ç Select the memory channel to be programmed.
Push [Y] or [Z] to select the memory channel (direct nu-
meral input cannot be used).
É Push [FUNC] then [EMW] for 1 sec. to program.
3 beeps may sound and the VFO contents (including the
subaudible tone frequency, etc.) are programmed.
Memory channel number advances when continuing to
push [MW] after programming.
Push
5 9
1
for 1 sec. and
continue pushing
5 9
1
M
MW
then
FUNC A
CLR
momentarily
1 1
5 9
1
M
9
5 5
M