Figure 7-8. Tftp Update Screen - ADTRAN MX2820 System Manual

MX2820 System Manual
Shelf: 1
Unacknowledged Alarms:
Selection :
7. Make sure the Firmware TFTP server IP address is set. Consult the network administrator
for this information.
8. Input the Remote Filename where the firmware image is located. This can include a path
and filename to the code image file.
9. Select
I T
NITIATE RANSFER
The upload routine begins and provides a status as follows:
a. Downloading the Image
b. Erase the Flash
c. Reprogramming the Flash
When the status indicates "Complete", the firmware is successfully upgraded.
10. Press to return to the Module Download Screen.
E
SC
11. Reset the module.
The SCU requires resetting before the new code revision takes effect.
a. From the MX2820 Main Menu screen, select
b. From the System Controller menu, select
c. From the Provisioning menu, select
d. Input a to confirm the reboot, and press
Y
The active MUX must be manually reset following download of new software to that
module. Select Card Reset from the MUX Provisioning menu. (The standby MUX, if
equipped, will perform a reset automatically.
7-52
ADTRAN MX2820 System
MAJOR MINOR
TFTP Update
1- TFTP Server
2- Remote Filename
3- Initiate Transfer

Figure 7-8. TFTP Update Screen

.
R
EBOOT
TID:
: 10.200.2.223
: downloads/scu/b01.bin
'?' - System Help Screen
S C
YSTEM ONTROLLER
and press
P
ROVISIONING
and press
SCU E
NTER
.
E
NTER
05/18/04 15:55
HTVLALEXD16
and press .
E
NTER
.
E
NTER
.
61186003L1-1D