Figure 7-37. Snmp Menu - ADTRAN MX2820 System Manual

5. From the Provisioning menu, select
Figure 7-37 shows the SNMP menu.
Shelf: 1
Unacknowledged Alarms: None
1 - Trap Host 1 IP
2 - Trap Host 2 IP
3 - Trap Host 3 IP
4 - Trap Host 4 IP
5 - ifIndex
6 - SCU Traps
7 - System Name
8 - System Location : SysLocation not set
9 - System Contact
10 - Read Community
11 - Write Community : private
Selection :
For step
ager IP addresses.
6. From the SNMP menu, select
7. From the Trap Host 1 IP menu, select 1, and press
8. Input Trap Host 1 IP address, and press
9. From the Trap Host 1 IP menu, select 2, and press
10. Input one of the following values, and press
• 1 - Valid
• 2 - Create Request
• 3 - Under Creation
• 4 - Invalid
11. Repeat steps 6 - 10
in step 6. After inputting this information, proceed to
12. From the SNMP menu, select
61186003L1-1D
Section 7, User Interface Guide - DLP-732, Provision SNMP Management Options
SNMP
ADTRAN MX2820 System
: 0.0.0.0
: 0.0.0.0
: 0.0.0.0
: 0.0.0.0
Method : Sequential (RFC2863)
: ENABLE
: HTVLALEXD16
: www.adtran.com
: public

Figure 7-37. SNMP Menu

6, the MX2820 system sends traps to these SNMP man-
T H
RAP OST
for Trap Host 2, 3, and 4, by selecting options 2, 3, and 4 respectively
I M
IF NDEX ETHOD
.
TID:
SNMP
'?' - System Help Screen
NOTE
.
1 IP
.
E
NTER
.
E
NTER
.
E
NTER
to set the Trap Host 1 Status:
E
NTER
step 12.
.
04/26/04 14:04
HTVLALEXD16
7-125