Programming Commands With Variable Arguments - YASKAWA XTRAWARE - V3.0 Manual

3. Set the arguments required for the command. See section 4.4.2,
Programming Commands with Variable Arguments, for instructions on
specifying the argument with a variable.
4. Click Program to add the command to the program in the Program
window.
The maximum length of a program is 180 command lines. If ECAM is
enabled, the maximum program length is 99 lines.
It is possible to edit the arguments of commands already listed in the
Program window:
To edit a programmed command:
1. Double-click a command in the Program window to open the command's
pop-up window.
2. Edit the arguments as desired and click Program.
To edit the order of programmed commands:
1. Use the standard Windows operations (Ctrl+X - cut, Ctrl+C - copy, and
Ctrl+V - paste) to re-order commands in the Program window.
When you have completed the program, it must be downloaded to the
XtraDrive.
To download a program to the XtraDrive:
1. Click Download Program
4.4.2. Programming Commands with Variable
Arguments
Instead of entering a number to specify the value of an argument, you can
set the argument to equal one of the system or user variables. The
variables that can be selected depend on the command being programmed.
Arguments that can be specified by variables are indicated by the letter V in
the Arg columns of the table in Chapter 11, List of Operation Codes, and in
the Syntax Arguments section of each command table in Chapter 5,
Command Reference.
This functionality is available in driver versions 3.0 and upward.
XtraWare User Manual
Operating the XtraDrive Using XtraWare
.
29