Installing Full-Height, Half-Length Pcie Boards In The Matrox 4Sight Xb Unit; Opening The Side Door Of The Matrox 4Sight Xb Chassis - Matrox 4Sight X Installation And Hardware Reference

Installing full-height, half-length PCIe boards in the Matrox 4Sight XB unit

Installing full-height, half-length PCIe boards
in the Matrox 4Sight XB unit
The fastest way to install a full-height, half-length PCIe board in the unit is to
open the side door of the chassis and insert the board, as described below.
❖ Note that, instead of opening the side door, you can remove the chassis cover and
insert/remove the board, but this takes more time. If you want to remove the chassis
cover, see Removing the Matrox 4Sight X chassis cover section, earlier in this chapter.

Opening the side door of the Matrox 4Sight XB chassis

To open the side door of the chassis, remove the screws on the door; then, swing
the door downward, as shown in the illustration below.
First, remove these screws
67
Then, swing
side door
down