Networking Connections - Matrox 4Sight X Installation And Hardware Reference

36 Chapter 2: Connecting peripherals to the unit
Required cabling
for Ethernet
connections

Networking connections

You can connect Matrox 4Sight X to your local area network (LAN). To do so,
connect a network cable to one of the two GigE Ethernet connectors, located on
the front panel of the chassis.
Matrox 4Sight X can gain access to a LAN via Gigabit Ethernet (1000BaseT), Fast
Ethernet (100BaseT), or Twisted Pair Ethernet (10BaseT) through the two GigE
Ethernet connectors.
If you plan to use Gigabit Ethernet, use a Category 5e (CAT5e) cable. If you plan
to use Fast Ethernet, use a Twisted Pair Category 5 (UTP5) cable. If you plan to
use Twisted Pair Ethernet, use a UTP5 or UTP3 cable.
An RJ45 connector (shown below) must be attached to each end of the cable.