Table of Contents
Advertisement
Details
Installed Outputs
The
Installed Outputs
lists all the currently selected
outputs. To remove or edit
an output type, select it in the
Installed Outputs
• Select
Remove
output.
• Select
to change the
Edit
settings.
• Select
to add a new
New
output.
Output
Select which marker type to export.
Port
Select the Ethernet port or serial port you want to use for the communication.
Inspect Port
Select
Inspect Port
relevant port setup dialog box opens. You are not permitted to make any changes.
You cannot define the communication port parameters here. If you need to adjust
these, you must select
The
page is located in the
I/O Setup
Monitor
Select
Monitor
allows you to study the communication stream on the chosen serial line or local
area network (LAN) port.
Targets
Select which datagram format(s) to export.
MDS (Measured Data Shoal)
Simrad MDS is a proprietary datagram format created by Kongsberg
Discovery. It contains the location, bearing and depth of a tracked target.
All information is presented relative to your own vessel. All data are related
to the tracked target.
TPP (Tracked Target Position)
Simrad TPP is a proprietary datagram format created by Kongsberg
Discovery. It exports the horizontal range, bearing and depth of a tracked
target. All data are related to the tracked target.
381294/E
box
box.
to delete the
to check the communication parameters for the port. The
after you have defined the data output parameters.
I/O Setup
Installation
to open the
Port Monitor
Functions and dialog boxes
and
dialog boxes.
Output
dialog box. The
Port Monitor
dialog box
519
Advertisement
Chapters
Table of Contents
