Kongsberg Simrad SN90 Reference Manual page 514

Simrad SN90 Reference Manual
Description
The SN90 software automatically scans
the Processor Unit to locate and identify
the available communication ports.
Once the software has established a list
of valid interfaces, you can set up and
control the communication parameters.
The page provides two lists;
I/O Setup
one for serial ports and one for Ethernet
(LAN) ports. Each list is supported with
a set of functions to set up and monitor
the communication ports. Select the port
you want to work with and then select
one of the buttons below the list.
Note
Use the page to add or delete serial ports and Ethernet (LAN) ports, and define
I/O Setup
the communication parameters for each port. Use the
which external sensors your SN90 system will import information from. To control the
data export, use the
Output
The page in the
Sensors
communication lines and sensors in use. All relevant status information is provided.
Open the
Diagnostics
When you work in the
changes made on a page. You must do this before you continue working on a different
page.
Details
Serial Ports
The table shows the available serial ports on the Processor Unit. The list is
automatically populated the first time you open the
installation. The list reflects the initial number of serial ports that are available.
If you add interface hardware to your computer, you must select
new ports to the list.
Name
This is the given identity of the serial port. By default, the ports are
numbered.
512
dialog box.
dialog box provides an overview of all the
Diagnostics
dialog box from the
Setup
dialog box, you must always select
Installation
Sensor Installation
menu.
page after a software
I/O Setup
page to define
to save the
Apply
to add the
Add
381294/E