Kongsberg Simrad SN90 Reference Manual page 108

Simrad SN90 Reference Manual
Tip
By default, a new manually initiated tracked object is automatically given priority status.
Relevant information about the priority target can be found in the lower left corner of
the view. If you think the text is small and hard to read, double-click on the text field.
This will increase the text size.
On the
User Settings Setup
not want new tracked targets to become priority targets. This page is located in the
dialog box. To open the page, select
Installation
Procedure
1 Place the cursor over the echo you wish to track.
2 Press
Position Track
or:
3 Place the cursor over the echo you wish to track.
4 Right-click to open the shortcut menu.
5 Select
Initiate Track
Result
The marker is shown as a small triangle with or without a short identifying label. Once
an echo has been provided with a marker in the display presentation it is regarded as
an object.
Note
If you change the tilt and bearing settings manually, the position track is disabled. If
you create a new marker and give this priority, the position track is disabled. The same
applies if you start a new target track.
Related topics
Operating panels, page 36
Objects menu, page 401
Shortcut menus, page 411
Operating procedures, page 82
Using the markers and tracking features, page 105
Using markers in the SN90 user interface, page 346
106
page, de-select
New Manually Initiated Track
on the Operating Panel.
.
on the
Installation Setup
if you do
menu.
381294/E