Kongsberg Simrad SN90 Reference Manual page 214

Simrad SN90 Reference Manual
system. For each relevant sensor you must insert the offset values that define the its
physical location relative to the vessel's coordinate system.
Note
Just making changes and selecting
Select what to install, define the relevant parameters, and then select
Procedure
1 Connect the receiver to an available communication port on the Processor Unit.
This is described in the Installation Manual.
2 Open the
Setup
3 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
4 On the left side of the
5 For , select External Objects to import information from relevant devices.
Type
6 Select which port you want to import the sensor information on.
7 If you want to check the communication parameters, select
Note
You cannot make any changes here. To change the communication parameters,
use the
I/O Setup
8 If you want to check that the peripheral system is transmitting data to the SN90
system, select
Monitor
The
Port Monitor
), and one for outgoing messages (
Data
knowledge of the data communication to investigate the datagrams. The
dialog box is a tool for debugging purposes. It is neither required nor
Monitor
intended for normal operation of the SN90 system.
9 Type a custom name to identify the interface in other dialog boxes.
10 Select which datagram(s) you want to import from the sensor.
11 If relevant, specify a dedicated talker ID.
12 Select to save the new sensor interface you have defined.
Add
The sensor interface is added to the
page.
13 At the bottom of the dialog box, select
212
at the bottom of the page will not install anything.
OK
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
page.
.
dialog box provides one text box for incoming messages (
Installed Sensors
.
Sensor Installation
). Use these boxes and your
Tx Data
list on the
to save your settings.
Apply
.
Add
.
.
Inspect Port
Rx
Port
Sensor Installation
381294/E