Kongsberg Simrad SN90 Reference Manual page 567

Note
Just making changes and selecting
Select what to install, define the relevant parameters, and then select
A summary of all the sensors that are connected to the SN90 system is provided in the
dialog box.
Diagnostics
Details
Installed Sensors
The
Installed Sensors
contains all the sensors that
are currently installed on the
SN90 system. Select a sensor
in the list to edit its interface
properties, or to remove it.
Select in the list to add
New
a new sensor interface to the
SN90 system.
Type
The SN90 system can
communicate with several
different sensor types. Under
, select which type of
Type
sensor you want to receive
information from.
Tip
The page in the
Sensors
communication lines and sensors in use. All relevant status information is
provided. Open the
Port
To import the data from the chosen sensor you need to define an input port. This can
be any available Local Area Network (LAN) or serial line on your Processor Unit.
We recommend that you set up the relevant communication parameters before you
use the port. To set up the communication parameters, use the
page is located in the
I/O Setup
Inspect Port
Select
Inspect Port
relevant port setup dialog box opens.
The communication parameters defined for NMEA 0183 are:
• : 4800 bit/s
Baud rate
381294/E
at the bottom of the page will not install anything.
OK
list
dialog box provides an overview of all the
Diagnostics
dialog box from the
Diagnostics
Installation
to check the communication parameters for the port. The
Functions and dialog boxes
Add
menu.
Setup
I/O Setup
and dialog boxes.
Output
.
page. The
565