Kongsberg Simrad SN90 Reference Manual page 524

Simrad SN90 Reference Manual
You cannot define the communication port parameters here. If you need to adjust
these, you must select
The page is located in the
I/O Setup
Monitor
Select
Monitor
allows you to study the communication stream on the chosen serial line or local
area network (LAN) port.
Add
Select to start export of the chosen data format. Once an output type has been
Add
defined, it is listed in the
Remove
Once an output type has been defined, it is listed in the
the left side of the page. To remove the output, select the relevant format under
Installed Outputs
Edit
Once an output type has been defined, it is listed in the
left side of the page. To change the output settings, select the relevant format under
Installed Outputs
Save
Select to keep the changes you have made.
Save
Related topics
Exporting sensor data, marker positions and technical information, page 183
Functions and dialog boxes, page 416
Operation menu: functions and dialog boxes, page 429
Output dialog box, page 437
Screen Recording page
The
Screen Recording
video file. Use the
Screen Recording
Prerequisites
The dialog box is not available when your SN90 system is set to Inactive mode.
Output
How to open
This page is located in the
522
after you have defined the data output parameters.
I/O Setup
Installation
to open the
Port Monitor
Installed Outputs
, then select
Remove
, then select . Select
Edit
function allows you to record and save the echo presentation as a
page to define where the video files are saved.
dialog box. To open, select it on the
Output
and
Output
dialog box. The
Port Monitor
box on the left side of the page.
Installed Outputs
.
Installed Outputs
to keep the changes you have made.
Save
dialog boxes.
dialog box
box on
box on the
menu.
Operation
381294/E