Kongsberg Simrad SN90 Reference Manual page 201

Context
The
Sensor Installation
sensors and systems. You must specify which communication port to use (LAN (Local
Area Network) or serial port). You can type a custom name to identify the sensor import.
In the list of valid datagram formats, select the format(s) to be accepted by the SN90
system. For each relevant sensor you must insert the offset values that define the its
physical location relative to the vessel's coordinate system.
Note
Just making changes and selecting
Select what to install, define the relevant parameters, and then select
Procedure
1 Connect the navigation system to an available communication port on your
computer.
This is described in the Installation Manual.
2 Open the
Setup
3 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
4 On the left side of the
5 For , select the GPS sensor to import information from a global positioning
Type
system.
6 Select which port you want to import the sensor information on.
7 If you want to check the communication parameters, select
Note
You cannot make any changes here. To change the communication parameters,
use the
I/O Setup
8 If you want to check that the peripheral system is transmitting data to the SN90
system, select
Monitor
The
Port Monitor
), and one for outgoing messages (
Data
knowledge of the data communication to investigate the datagrams. The
dialog box is a tool for debugging purposes. It is neither required nor
Monitor
intended for normal operation of the SN90 system.
9 Type a custom name to identify the interface in other dialog boxes.
381294/E
page allows your SN90 system to communicate with external
at the bottom of the page will not install anything.
OK
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
page.
.
dialog box provides one text box for incoming messages (
.
Sensor Installation
). Use these boxes and your
Tx Data
Maintenance procedures
.
Add
.
.
Inspect Port
Rx
Port
199