Table of Contents
Advertisement
e
In the browser address field, type: http://157.237.60.20:5000
Note
If you have previously changed the IP Address on the Operating Panel, you
must use this address to open the configuration page.
3
If you use the Processor Unit:
a
Select
Power off
b
In the
Power Off
the SN90 program.
c
If applicable: Connect the keyboard and the mouse to USB sockets
on the Processor Unit.
d
From the Windows
e
Insert the USB flash drive.
f
Copy the file to a folder on the Processor Unit, but do not unpack it.
g
Remove the USB flash drive.
h
On the Processor Unit desktop, open folder
i
Double-click the URL shortcut to open the Operating Panel configuration page
in the default web browser.
Note
If you have previously changed the IP Address on the Operating Panel, you
must use this address to open the configuration page.
4
Do the firmware update.
a
In the browser window, select
b
Select
Perform update
c
Locate the firmware update file and select
d
Select
OK
The firmware update will now take place. The web browser will reload. You
may need to refresh the web browser after some time.
e
Make sure that the correct versions have been installed:
Refer to the software release note.
5
If you use a separate computer:
a
Disconnect the Operating Panel from the computer.
b
Connect the Operating Panel to the Processor Unit. (Ethernet cable)
6
On the Processor Unit desktop, double-click the SN90 icon to start the program.
7
Restore normal operation.
381294/E
to turn off the system.
dialog box, select
®
button, right-click to open File Explorer.
Start
Update
.
when prompted to update.
Maintenance procedures
Exit to Operating System
SIMRAD-Shortcut
.
.
Open
to close
.
251
Advertisement
Chapters
Table of Contents
