Kongsberg Simrad SN90 Reference Manual page 523

Description
The information imported to the SN90 system
from various sensors can also be useful for other
systems on board your vessel. The SN90 system
allows you to "re-export" this sensor information.
When activated, the selected sensor information
is sent out on the chosen communication port
(serial or LAN).
The following sensor data can be exported:
• Navigation
• Motion sensor
Once an output type has been defined, it is listed in the
side of the page. To see the relevant output parameters, select any output in the list. You
can edit the output parameters, or delete the output format to stop the export.
In this context, the phrase "sensor" is used to describe an external device providing
information. This information is useful or essential for the operation of the SN90
system. Typical sensors are those providing navigational information (heading,
speed or geographical position) or vessel movements in the sea (motion sensors).
You cannot define the communication port parameters here. If you need to adjust these,
you must select
I/O Setup
page is located in the
Setup
Details
Installed Outputs
The
Installed Outputs
an output type, select it in the
• Select
Remove
• Select to change the settings.
Edit
• Select
New
Output
Select which information to export. The following sensor data can be exported:
• Navigation
• Motion sensor
Port
Select the Ethernet port or serial port you want to use for the communication.
Inspect Port
Select
Inspect Port
relevant port setup dialog box opens. You are not permitted to make any changes.
381294/E
after you have defined the data output parameters. The
and
Installation
box lists all the currently selected outputs. To remove or edit
Installed Outputs
to delete the output.
to add a new output.
to check the communication parameters for the port. The
Functions and dialog boxes
Installed Outputs
dialog boxes.
Output
box.
box on the left
I/O
521