Kongsberg Simrad SN90 Reference Manual page 572

Simrad SN90 Reference Manual
Tip
The SN90 system can communicate with several different sensor types. Use the
page to define which external sensors your SN90 system will import
Installation
information from. You must also specify which datagram formats to use. The
page is located in the
Installation
A summary of all the sensors that are connected to the SN90 system is provided in the
dialog box.
Diagnostics
When you save echo data in RAW format, all sensor data are included.
Note
If you have two sensors providing the same information, but on different communication
ports, certain limitations apply. During normal operation, you can easily decide which
sensor you wish to use. During replay, you can only play back from one of these sensors.
For this reason, only the information from the currently "active" sensor is saved.
When you work in the
changes made on a page. You must do this before you continue working on a different
page.
Details
Sensor
All the sensors are listed. Select a sensor in this list to set up the datagram priority
and/or configuration.
Tip
You can set up datagram priorities for both heading and course information on the
Sensor Configuration
line in the relevant views. When enabled, the vessel's current heading is shown
on the top bar. If the information from the heading sensor fails, the top bar will
change to present the course information instead.
Auto
Select to control the functionality.
Auto
• With enabled, the priority list is used. Information is imported from the
Auto
sensor at the top of the list. If the sensor fails to provide information for more
than 20 seconds, data from the next sensor is used.
• With disabled, the priority list is not used. Information is imported from
Auto
the sensor at the top of the list. All other sensors are ignored.
570
Installation
dialog box, you must always select
Installation
page. The course information is used to present the Course
dialog box.
Sensor
Sensor
to save the
Apply
381294/E