Kongsberg Simrad SN90 Reference Manual page 244

Simrad SN90 Reference Manual
e Connect the power cable from the Ethernet switch to the AC power outlet.
f Do not connect the Operating Panel to the Ethernet switch.
Ethernet cables
Tip
An Ethernet switch connected to ETH1 on the rear side of the Processor Unit can also be
used to interface other peripheral systems such as echo sounders and positioning systems.
You can also connect the Olex system to the SN90 system using this Ethernet switch.
2 Change the IP Address on the primary Operating Panel.
Note
Each Operating Panel must have a different IP Address. None of the panels must
use the default IP Address. If you have previously changed the IP Address on the
Operating Panel, you can proceed to the next step.
a On the Operating Panel, press
The blue indicator light in the button flashes while the Operating Panel
establishes contact with the Processor Unit. When the connection has been
made, the blue indicator light is lit permanently.
b On the Processor Unit desktop, open folder
c Double-click the URL shortcut to open the Operating Panel configuration page
in the default web browser.
d Select
SOP Configuration
e In the
SOP IP
157.237.60.xx
The last digit "xx" in the IP Address can be any number between 21 and 29.
242
Power
on the top menu to open the page.
field, change the IP Address from the default value to:
, and keep it depressed for a few seconds.
SIMRAD-Shortcut
.
381294/E