Table of Contents
Advertisement
sensor information. When activated, the selected sensor information is sent out on the
chosen communication port (serial or LAN).
The following sensor data can be exported:
• Navigation
• Motion sensor
Procedure
1
Open the
Setup
2
Select
.
Output
Observe that the
pages selected from the menu on the left side.
3
On the left side of the
4
On the
Relay Output
a
Select which information to export.
b
Select the communication port you want to use.
c
Select
Add
5
If you want to check the communication parameters, select
Note
You cannot make any changes here. To change the communication parameters, use
the
page. The
I/O Setup
dialog boxes.
6
If you want to check the data flow on the selected port, select
In order to see this data traffic, your SN90 system must be active and transmitting
information to the peripheral system.
The
Port Monitor
), and one for outgoing messages (
Data
knowledge of the data communication to investigate the datagrams. The
dialog box is a tool for debugging purposes. It is neither required nor
Monitor
intended for normal operation of the SN90 system.
7
Select
and then
Apply
box.
Related topics
Operating procedures, page 82
Exporting sensor data, marker positions and technical information, page 183
Relay Output page, page 520
381294/E
menu.
dialog box opens. This dialog box contains a number of
Output
dialog box, select
Output
page, set up the data export parameters.
to start export of the chosen data format.
page is located in the
I/O Setup
dialog box provides one text box for incoming messages (
to save all the parameters and close the
Close
Relay Output
Inspect Port
Installation
). Use these boxes and your
Tx Data
Operating procedures
.
.
and
Output
.
Monitor
Rx
Port
dialog
Output
185
Advertisement
Chapters
Table of Contents
