Fault; Troubleshooting - Angelo Po 0N1CP1GL User Manual

ENGLISH
The appliance has been tested before being
put into service. The information provided be-
low is intended to assist in the identifi cation
and correction of any anomalies and malfun-
ctions which might occur during use.
The user can solve some of these problems
himself, but for others specifi c technical
knowledge or skill is required, and so they must
only be carried out by qualifi ed staff with reco-
gnised experience acquired in the specifi c sec-
tor of operation.
Faults
Smell of gas
The pilot light does not
ignite
The pilot light goes out
The fl ame is yellow
Burner control knob is stiff
24

FAULT

TROUBLESHOOTING

Angelo Po's agents or headquarters, which
can be found in the contacts section of the
website www.angelopo.com.
Causes
Occasional leak because fl ame
has gone out
The spark ignition devices are
not working
Air in pipelines due to long
period out of use
The thermocouple has not
warmed up enough
Burner dirty, heat exchange
pipes clogged, condensation
drips
Gas control valve malfunction
NOTE: For any need, please contact
Turn off the gas supply tap
and ventilate the room
Check that the ignition devices
are in good working order.
NOTE: Contact the
after-sales service.
Make more attempts to light
Make more attempts to light
NOTE: Contact the
after-sales service.
NOTE: Contact the
after-sales service.
FAULT
Remedies
the fl ame
the fl ame
3433210_ut_GB