Replacing Parts; Instructions And Warnings For The Replacement Of Parts; Replacement Of The Burner Nozzle - Angelo Po 0N1CP1GL User Manual

ENGLISH

INSTRUCTIONS AND WARNINGS FOR THE REPLACEMENT OF PARTS

NOTE: Read the following section of
the "user instruction manual" carefully be-
fore replacing any part:
– Hazards and safety provisions during instal-
lation and commissioning, adjustments and
part replacement.
WARNING: Before carrying out any
replacement procedure, activate all the safe-
ty devices provided and decide whether staff
at work and those in the vicinity should be in-
formed.
In particular, turn off the gas supply tap, cut
off the electricity supply using the master
switch and prevent access to all devices that
might cause unexpected health and safety
hazards if turned on.
To carry out this operation, proceed as follows.
Open the hatch (A).
)
Unscrew the nozzle (D) and replace it with
)
the one suitable for the type of gas in use
(see table at back of manual).
)
Replace all when the operation is complete.
18

REPLACING PARTS

REPLACEMENT OF THE BURNER NOZZLE

Also make sure that during the mainte-
nance procedure, that the operator is al-
ways able to check whether the plug is dis-
connected from the power outlet.
If work parts have to be replaced, use orig-
inal spare parts only. The manufacturer de-
clines all responsibly for injury or damage to
components due to the use of non original
parts, or extraordinary work on the appli-
ance which may modify the safety require-
ments without the manufacturer's authori-
sation. When ordering components, follow
the instructions provided in the parts cata-
logue.
A
REPLACING PARTS
D
3433210_inst_GB