Table of Contents
Advertisement
The appliance has been tested before being put into
service. The information provided below is intended
to assist in the identification and correction of any
anomalies and malfunctions which might occur dur-
ing use. The user can solve some of these problems
Smell of gas.
The pilot light does not ignite.
The pilot light goes out.
The pilot light ignites but the burner
The flame is yellow.
IT
Burner control knob is stiff.
AUS
DE
FR
ES
TROUBLESHOOTING
Fault
remains off.
FAULT
himself, but for others specific technical knowledge or
skill is required, and so they must only be carried out
by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Causes
Occasional leak because flame
has gone out.
The spark ignition devices are not
working.
Air in pipelines due to long period
out of use.
The thermocouple has not warmed
up enough.
Burner dirty, heat exchange pipes
clogged, condensation drips.
Gas control valve malfunction.
- 10 -
Remedies
Turn off the gas supply tap and
ventilate the room.
Check that the ignition devices are
in good working order. Light by
hand with a naked light.
Important
Contact the
after-sales service.
Make more attempts to
light the flame.
Make more attempts to
light the flame.
Check the condition of the
thermostat and activate any
ignition enabling device.
Contact the after-sales service.
Contact the after-sales service.
6
Advertisement
Table of Contents
