Fault; Troubleshooting - Angelo Po 1N1BR2G User Manual

ENGLISH
The appliance has been tested before being
put into service. The information provided be-
low is intended to assist in the identifi cation
and correction of any anomalies and malfun-
ctions which might occur during use.
The user can solve some of these problems
himself, but for others specifi c technical
knowledge or skill is required, and so they must
Faults
Smell of gas.
The pilot light goes out.
The pilot light does not
ignite.
The pilot light ignites but the
burner remains off .
The fl ame is yellow.
Burner control knob is stiff .
No water delivered.
24

FAULT

TROUBLESHOOTING

only be carried out by qualifi ed staff with reco-
gnised experience acquired in the specifi c sec-
tor of operation.
Angelo Po's agents or headquarters, which
can be found in the contacts section of the
website www.angelopo.com.
Causes
Occasional leak because
fl ame has gone out.
The thermocouple has not
warmed up enough.
The spark ignition devices
are not working.
Air in pipelines due to long
period out of use.
Burner dirty, heat exchange pi-
pes clogged, condensation drips.
Gas valve malfunction.
Filler solenoid valve faulty.
Filling switch malfunction.
Well raised or not resting on
fi xed part of appliance.
NOTE: For any need, please contact
Remedies
Turn off the gas supply tap and
ventilate the room.
Make more attempts to light the
fl ame.
Check that the ignition devices
are in good working order.
Light by hand with a naked light.
NOTE: Contact the
after-sales service.
Make more attempts to light the
fl ame.
Check the condition of the ther-
mostat and activate any ignition
enabling device.
NOTE: Contact the
after-sales service.
NOTE: Contact the
after-sales service.
Check the pressure switch con-
nection.
NOTE: Contact the
after-sales service.
Check the water connection.
NOTE: Contact the
after-sales service.
Check that the well is not raised or
not resting fi rmly on fi xed part of
appliance.
3301311_ut_GB_rev.1
FAULT