Handling And Lifting; Installation Of The Appliance - Angelo Po 0N1CP1GL User Manual

HANDLING AND INSTALLATION
The appliance can be handled using fork-lift or
hook equipment of suitable load-carrying ca-
pacity.
Before lifting, check the position of the load's
centre of gravity.
IMPORTANT: When engaging the
lifting device, watch out for the intake and
outlet pipes.
All installation stages must be considered right
from production of the general layout.
Before starting these stages, as well as deciding
the place of installation, if necessary, the per-
son authorised to carry out these operations
must organise a "safety plan" to protect the pe-
ople directly involved, and he must also ensu-
re strict compliance with all legal requirements,
especially those relating to mobile work-sites.
The place of installation must have all the con-
nections needed to supply the appliance and
dispose of the production residues, must be
suitably lit and must meet all legal health and
hygiene requirements to prevent the contami-
nation of the foods.
If necessary, fi x the exact position of each indi-
vidual appliance or subassembly by mark coor-
dinates to locate them correctly. (see explana-
tory diagram).
IMPORTANT:The unit is not suitable
for built-in installation.
WARNING: Do not install the unit
next to walls made of fl ammable material.
3433210_inst_GB

HANDLING AND LIFTING

INSTALLATION OF THE APPLIANCE

WARNING: Do not install the unit on
uneven, soft or sloped fl oors.
WARNING: Leave a gap of at least 5
cm from the wall when installing the appli-
ance.
The installation must be in accordance with the
applicable legislation, regulations and specifi -
cations in the country of use.
ENGLISH
9