Replacement Of The Pilot Light Injector; Equipment Decommissioning, Demolition And Disposal; 3433210_Inst_Gb - Angelo Po 0N1CP1GL User Manual

REPLACING PARTS
To carry out this operation, proceed as fol-
lows.
)
Turn off the gas supply tap.
)
Disconnect the electricity supply.
Open the hatch (A).
)
Unscrew fi tting (E).
)
Remove the nozzle (D) and replace it with
)
the one suitable for the type of gas in use
(see table at back of manual).
)
Replace all when the operation is complete.

EQUIPMENT DECOMMISSIONING, DEMOLITION AND DISPOSAL

NOTE: Read the following section of
the "user instruction manual" carefully be-
fore replacing any part:
– Hazards and safety provisions during decom-
missioning.
When decommissioning the appliance, a series
of procedures must be carried out to ensure
that the appliance and its components are not
a hindrance and are not easily accessible.
To ensure that the appliance cannot constitute
hazards for people or the environment, all en-
ergy sources (electricity, etc.) must be discon-
nected and rendered unusable, and any liq-
uids present must be drained (lubricants, fl uids,
etc.).

3433210_inst_GB

REPLACEMENT OF THE PILOT LIGHT INJECTOR

A
Place the appliance in a suitable area which is
not easily accessible, with barriers to prevent
anyone from accessing it.
When scrapping, sort all components by chem-
ical characteristics and dispose of them sepa-
rately in accordance with the relevant legal re-
quirements.
IMPORTANT: Do not dump non-bio-
degradable products, lubricating oils, and
non-metallic components (rubber, PVC, re-
sins, etc.) in the environment. Dispose of
them in compliance with the relevant laws.
ENGLISH
E
D
19