Table of Contents

Advertisement

CHECKING GAS PRESSURE
To carry out this operation,
proceed as follows.
1 - Turn off the gas supply
tap.
2 - Pull off knob (A) and dis-
assemble handle (B).
3 - Undo the screws (C) and
remove panel (D).
4 - Undo the screw (E) of the
pressure connection.
5 - Connect the pressure
gauge (F) to the pressure
test point.
6 - Fill the well with water and turn the tap back on.
7 - Light the burner and turn the knob to the full flame
setting (see page 6), then check that the pressure
reading complies with the values in the table (see
TROUBLESHOOTING
The appliance has been tested before being put into
service. The information provided below is intended
to assist in the identification and correction of any
anomalies and malfunctions which might occur dur-
ing use. The user can solve some of these problems

Fault

Smell of gas.
The pilot light does not ignite.
The pilot light goes out.
The pilot light ignites but the
burner remains off.
The flame is yellow.
Burner control knob is stiff
B
A
C D C
8 - Turn off the burner, disconnect the pressure
FAULT
himself, but for others specific technical knowl-
edge or skill is required, and so they must only be
carried out by qualified staff with recognised ex-
perience acquired in the specific sector of operation.
Causes
Occasional leak because flame has
gone out.
The spark ignition devices are not
working.
Air in pipelines due to long period out of
use.
The thermocouple has not warmed up
enough.
Burner dirty, heat exchange pipes
clogged, condensation drips.
Gas control valve malfunction.
- 9 -
back of manual).
gauge and restore the initial conditions after com-
pleting the operation.
Turn off the gas supply tap
and ventilate the room.
Check that the ignition
devices are in good working order.
Light by hand with a naked light.
Important
Contact the after-sales service.
Make more attempts to light the
Make more attempts to light the
Check the condition of the
thermostat and activate any
ignition enabling device.
Contact the after-sales service.
Contact the after-sales service.
F
E
IDM-39604005500.tif
6
Remedies
flame.
flame.
IT
AUS
DE
FR
ES

Advertisement

Table of Contents
loading

Table of Contents