Checking Gas Pressure; Fault; Troubleshooting - Angelo Po 0N1CP1GL User Manual

FAULT

To carry out this operation, proceed as follows.
) Turn off the gas supply tap.
Pull off the knob (A).
)
Remove the knob unit (B).
)
Undo the screws (C) and remove the control
)
panel (D).
Undo the screw (E) of the pressure connec-
)
tion.
Connect the pressure gauge (F) to the pres-
)
sure test point (G).
B
See paragraph "TROUBLESHOOTING" of the
User instructions manual.
3433210_inst_GB

CHECKING GAS PRESSURE

D
A
C
FAULT

TROUBLESHOOTING

)
Turn the gas supply tap back on.
) Switch on the burner and turn the knob to
the maximum temperature setting (see "
User instructions manual"), then check that
the pressure reading complies with the val-
ues provided in the table at the back of the
manual.
) Switch off the burner, turn off the gas supply
tap and disconnect the pressure gauge.
)
Restore the initial conditions after complet-
ing the operation.
F
C
ENGLISH
G
E
7