Cleaning Oven; Fault; Troubleshooting - Angelo Po 1N1FAG User Manual

To carry out this operation, proceed as follows.
Remove the bottom plate (C) and the grid (D)
1)
from the oven and clean them thoroughly.
Clean the inside parts of the oven to remove
2)
any deposits which may impair its operation.
Dry the surfaces and reassemble the compo-
3)
nents.
The appliance has been tested before being put
into service. The information provided below
is intended to assist in the identifi cation and
correction of any anomalies and malfunctions
which might occur during use.
The user can solve some of these problems
himself, but for others specifi c technical
knowledge or skill is required, and so they
must only be carried out by qualifi ed staff with
recognised experience acquired in the specifi c
sector of operation.
GB Faults
Smell of gas
The pilot light does not
ignite.
The pilot light goes out.
3319970_ut_GB_rev.1

CLEANING OVEN

FAULT

TROUBLESHOOTING

For all requirements contact the agents or
the headquarters of Angelo Po which can be
found in the contacts section of the website
http://www.angelopo.com.
Causes
Occasional leak because
fl ame has gone out.
The spark ignition devices are
not working.
Air in pipelines due to long
period out of use.
The thermocouple has not
warmed up enough.
- 14 -
C
D
Important
Remedies
Turn off the gas supply tap and
ventilate the room.
Check that the ignition devices
are in good working order. Light
by hand with a naked light.
Important
Contact the after-sales service.
Make more attempts to light the
fl ame.
Make more attempts to light the
fl ame.
ENGLISH