Fastening The Mount - Kaco Blueplanet 87.0 TL3 Series Manual

Legend
1 Hood
2 Upper side section
3 Clip lock (4x)
6.3

Fastening the mount

CAUTION
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons in front of the device may be seri-
ously injured.
› Use only fixing materials that are suitable for the mounting base. The fastening materials supplied are
only suitable for masonry and concrete.
› Only install the device in an upright position.
6 1/32"
2 61/64"
B
A
D
C
Fig. 16: Minimum clearances for wall mounting
Legend
1 Mount
2 Fixings for mounting [S12 – Ø 12mm/ 90mm]*
3 Lock washer
A Minimum clearance: 120
Recommended clearance: 400
B Minimum clearance: 300
C Minimum clearance: 500
D Recommended clearance: 1000
↻ Cardboard packaging with mount and mounting kit removed from the packaging and opened.
1 Mark the mounting position on the wall surface according to the position of the mount by drawing a line.
2 Mark the positions of the drill holes using the slot in the mount.
NOTE: The minimum clearances between two devices, or the device and the ceiling/floor have already been taken
into account in the diagram.
3 Fix the mount to the wall using suitable mounting fixtures from the mounting kit.
NOTE: Make sure that the mount is oriented correctly.
» Proceed with the installation of the device.
Page 18
2
1
6
3
4
5
A
KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 110 TL3 KACO blueplanet 125 TL3
4 Base section
5 Lower side section
6 Cardboard packaging with mount and mounting kit
550 mm
453 mm
458 mm
1066 mm
2)
1543 mm
1)
475 mm
1)
270 mm
1)
475 mm
1)
270 mm
Fig. 17: Wall mounting
4 Screw for mounting (4x) [SW 13 / Fastening the
mount [See section 6.3} Page 18]]
5 Securing screw (1x)
6 Lug to mount the device
1)
Minimum clearance excluding device:270
1)
Recommended clearance excluding device: 475
- -
- -
²) Recommended clearance with DC breaker: 1543
KACO blueplanet 137 TL3 KACO blueplanet 150 TL3
1
5
6