Copying - Ricoh Aficio FAX 5000L Operating Instructions Manual

Copying

This section describes how to make
copies.
Important
When making multiple copy sets,
copying starts once all originals
have been scanned into memory. If
memory runs out (free memory
reaches 0%) while scanning in, the
copy job is canceled and originals
that have been scanned in so far
are deleted from memory.
Limitation
The margins of error when copy-
ing at 100% magnification are as
follows:
• Horizontal: +2.0%, –2.5%
• Vertical: +1.5%, –2.0%
You can specify between 1 and 99
copies.
You cannot interrupt a fax opera-
tion while it is in progress to make
copies.
In copy mode you cannot set the
Resolution to Fine.
Note
Set your original and select any
scan settings in the same way as
for fax transmission.
Recommended originals are the
same as recommended documents
for fax transmission.
Multiple copy sets are sorted and
delivered in page order.
If you wish to prevent passersby
from freely making copies, you can
disable the copy feature with the
6. Copying
User Parameters(⇒ P.236). By de-
fault, the copy feature is enabled.
A
Make sure that the machine is in
standby mode.
Note
If the "Fax Features" or "Key
Op. Tools" screen in shown,
press the {User Tools} key. If any
other display is shown, press
the {Clear Modes/Energy Saver}
key.
B
Press the {Copy} key.
If you press this key again, the
original display reappears.
C
Set your original and adjust any
scan settings as necessary.
161