Table of Contents
Advertisement
Key Operator Tools
Switch Bit
10
1
2
3
4
7
11
0
1
5
6
7
12
2
4,3
7
13
1,0
3,2
9
How to set the User Parameters
This example shows how to change
the default transmission mode when
the machine is shipped from Memory
Transmission to Immediate Trans-
mission. To do this, we must change
switch 00 bit 6 from 0 to 1.
Important
• We recommend that you print
the User Parameter list and
keep it when you register or
change a user parameter.⇒
240
Item
Two in One
Image Rotation
Page Reduction
Rotate Sort
Halftone mode
Transfer Request By Tonal Signals
Selection of tone (PB) or UUI after
tone (·) (when the optional G4 Unit
is installed)
Whether "To" prefixes the label
when Label Insertion is turned on.
Print Forwarded Messages Locally
Polling Files After Transmission
Toner Saving Mode
Print Image Density
00: Normal*, 01: Lighten, 10: Darken
Copying
Use the main G3 line as an internal extension, or an outside line.
00:Outside Line, 01:Extension (PREFIX), 10:Extension (GND),
11:Extension (FLASH)
Use the extended G3 line as an internal extension, or an outside line.
00:Outside Line, 01:Extension (PREFIX), 10:Extension (GND),
11:Extension (FLASH)
0
Off*
Off*
Off*
Off*
Standard
Mode*
Off*
UUI
No
Off
Delete*
Off*
Possible*
P.242 "Printing the User Parame-
ter List"
• Do not change any bit switches
other than those shown on the
previous pages.
A
Make sure that the machine is in
standby mode.
1
On
On
On
On
Speed Mode
On
PB*
Yes*
On*
Standby
On
Not Possible
Advertisement
Table of Contents
