Kyocera TASKalfa 7002i Service Manual page 1072

Step Check description
11 Checking the PF convey-
ing sensor
12 Checking the PF convey-
ing clutch
13 Checking the PF feed
motor
14 Checking the drive parts
15 Checking the PF convey-
ing clutch
16 Checking the PF feed
motor
17 Checking the drive parts
Assumed cause
The PF conveying sensor
does not properly operate.
The PF conveying clutch
does not properly operate.
The PF feed motor does
not properly operate.
The drive from the PF feed
motor is not properly trans-
mitted.
The PF conveying clutch
does not properly operate.
The PF feed motor does
not properly operate.
The drive from the PF feed
motor is not properly trans-
mitted.
7-212
Measures
Reattach PF conveying sen-
sor 1 and reinsert the con-
nector. If not repaired,
replace the sensor. (Side
multi feeder)
Execute U247 [SMT] >
[Clutch] > [Feed1 Clutch]. If
PF conveying clutch 1 does
not properly operate, reattach
it and reinsert the connector.
If not repaired, replace it.
Execute U247 [SMT] >
[Motor] > [On] or [Off]. If the
PF feed motor does not prop-
erly operate, reattach it and
reinsert the connector. If not
repaired, replace it.
Check if the PF feed motor
smoothly rotates by a hand.
Then, clean and reattach the
drive parts if necessary. If not
repaired, replace them. (Side
multi feeder)
Execute U247 [Side LCF] >
[Clutch] > [V Feed Clutch]. If
PF conveying clutch 1 does
not properly operate, reattach
it and reinsert the connector.
If not repaired, replace it.
Execute U247 [Side LCF] >
[Motor] > [On] or [Off]. If the
PF feed motor does not prop-
erly operate, reattach it and
reinsert the connector. If not
repaired, replace it.
Check if the PF feed motor
smoothly rotates by a hand.
Then, clean and reattach the
drive parts if necessary. If not
repaired, replace them.
(Large capacity feeder)
2WA/2NJ/2RK
Reference
Executing
U247
Executing
U247
Executing
U247
Executing
U247