Kyocera TASKalfa 7002i Service Manual page 659

U087 Setting the DP scanning position change operation
(Message: Set DP Scanning Position Operation)
Contents
If dust can be detected by comparing the original trailing edge scanned data with the scanned
data after the original feed, change the original scan position next time.
Also, reduce the black lines by image correction.
Purpose
Use as the corrective measures for the black lines appearing with dust on the original scanning
position when using the document processor.
Setting
1.Press the [Start] key.
2.Select the item to set.
3.By using the [+] [-] keys or the numeric keys, change the setting value.
Items
Front
Back
Black Line
* :If the set value is reduced, dark density image is regarded as dust and dust detection
becomes more likely.
If the set value is increased, dust detection becomes less likely.
Method: Black Line
1.Select [Clear].
2.Press the [Start] key.
* :Original scan position returns to the initial line.
Completion
Press the [Stop] key.
* :The screen for selecting a maintenance item No. is displayed.
Contents
Set the 1st side scanning data threshold
Setting the backside scanning data
threshold when scanning in duplex
Initialize the original scanning position
Setting range
0 to 255
0 to 255
6-66
2WA/2NJ/2RK-1
Data
variation
1
1
- -
Initial
setting
125
125
-