Kyocera TASKalfa 7002i Service Manual page 695

U161 Fuser temperature adjustment
(Message: Adjust Fuser Control Temperature)
Contents
Sets the fuser temperature.
Purpose
Normally no need to change. However, change the setting as corrective measures for paper curl,
creases and fusing failure on thick paper.
Method
1.Press the [Start] key.
2.Select the item to set.
* :The screen for setting is displayed.
Items
Warm Up
Print
Low Power Mode
Belt Mode
Ready Time Adjust
Setting: Warm Up
1.Select the item to set.
2.Change the setting value by using [+] [-] key or the numeric keypad.
Items
Ready(Center)
Ready(Edge)
Ready(Press)
Drive(Center)
Wait(Center)
Low Power
(Center)
Full Speed
Shift(Center)
Pressure
(Center)
3.Press the [Start] key and fix the setting value.
Control temperature except at printing
Control temperature at printing
Additional heat power control
Fuser drive control setting
Setting the low-temperature aging temperature
Contents
Control temperature at displaying Ready
(Center)
Control temperature at displaying Ready
(Edge)
Control temperature at displaying Ready
(Press)
Stable temperature during driving (Center)
Stable temperature during halt (Center)
Control temperature at low power (Center)
Full speed shift temperature (Center)
Pressurization beginning temperature
(Center)
6-102
Contents
Setting
range
130 to 200
100 to 200
0 to 200
130 to 200
160 to 200
0 to 200
0 to 200
0 to 200
2WA/2NJ/2RK