Kyocera TASKalfa 7002i Service Manual page 654

U071 Adjusting the DP leading edge Timing
(Message: Adjust DP Leading Edge Timing)
Contents
Adjusts the DP original scanning timing.
Purpose
Adjusted if there is a regular error between the leading or trailing edges of the original and the
copy image when the DP is used
Method
1.Press the [Start] key.
2.Press the [System Menu] key.
3.Place an original on the DP and press the [Start] key to make a test copy.
* :Check the duplex scanning by setting [Duplex] when test copying.
4.Press the [System Menu] key.
5.Select the item to adjust.
Items
Front Head
Front Tail
CIS Head
CIS Tail
*: Initial setting value is a reference value as the value changes by the adjustment at the production.
Adjustment: Front Head/CIS Head
1.Change the setting value by using [+] [-] key or the numeric keypad.
For the copy example 1, increase the value.
For the copy example 2, decrease the value.
* :When the setting value is increased, the image moves forward, and it moves backward
when the setting value is decreased.
2.Press the [Start] key to set the setting value.
Precautions
Check the 2nd side after adjusting the 1st side. Adjust if necessary.
Check the copy image after the adjustment. If the image is still incorrect, adjust the following in
the maintenance mode.
U034(P.6-38) > U071
Contents
Leading edge registration. (Front page)
Trailing edge registration. (Front page)
Adjusts the leading edge timing for the
CIS scanning
Adjusts the trailing edge timing for the CIS
scanning
Original
Setting range
Copy Copy
example 1 example 2
Figure 6-13
6-61
Data
variation
-27 to 27 0.30mm
-27 to 27 0.30mm
-27 to 27 0.30mm
-27 to 27 0.30mm
2WA/2NJ/2RK-2
Initial
setting
0
0
0
0