Kyocera TASKalfa 7002i Service Manual page 731

Setting: Punch Width
1.Select [Punch Width].
2.By using the [+] [-] keys or the numeric keys, change the setting value.
Content to adjust
Punch center position timing adjustment
* :Reduce the specified value if the punch position is shorter than specified.
Increase the specified value if the punch position is longer than specified.
Center line
(within ± 0.5 mm)
3.Press the [Start] key to set the setting value.
Setting: Width Front HP / Width Tail HP
1.Select [Width Front HP] or [Width HP].
2.Change the setting value by using [+] [-] key or the numeric keypad.
Content to adjust
Front width adjuster home position adjust-
ment
Rear width adjuster home position adjustment
3.Press the [Start] key to set the setting value.
4.Press the [Stop] key to return to the screen to select the maintenance item No.
5.Enter U240 and select [Motor] and then [Width Test(A4R)].
* :The middle tray side registration guides move to A4R size position.
6.Insert paper into the side registration guides to check the consistence.
7.Repeat the above adjustment until the consistency is appropriate.
Setting: Shift Front HP / Shift Tail HP
1.Select [Shift Front HP] or [Shift Tail HP]
2.Change the setting value by using the [+] [-] keys or the numeric keys.
Content to adjust
Adjustment of front shift home position
Adjustment of rear shift home position
3.Press the [Start] key and confirm the setting value.
4.Press the [Stop] key and return back to maintenance mode number selection screen.
5.Enter U240 and select [Motor] and then [Sort Test].
6.Check consistency of the exit paper and repeat the above adjustment until paper is properly in
position.
Setting
range
-4 to 4
Sample 1
Setting
range
-30 to 30
-30 to 30
Setting
range
-30 to 30
-30 to 30
6-138
2WA/2NJ/2RK-1
Data varia- Initial setting
tion
0.52 mm
Sample 2
Data varia- Initial setting
tion
0.19mm
0.19mm
Data varia- Initial setting
tion
0.19mm
0.19mm
0
0
0
0
0