Advanced Setting Mode - M-system 47DAC Operating Manual

36.4.4 ADVANCED SETTING MODE

■ LOCKOUT 'LV0' (COMPLETELY UNLOCK ADVANCED SETTING MODE)
*1
Selectable only with the I/O option code '6' or 'A' (event trigger input).
*2
Selectable only with the I/O option code '5' , '9' or 'A' (BCD output).
NOTE
• With the event trigger mode set to "normal" , the ON timing delay and OFF timing delay are disabled.
• With the event trigger mode set to "sampling hold" , the OFF timing delay is disabled.
• With the low-end cutout set to OFF, the low-end cutout value setting is locked.
Measuring Mode
High-pass lter
OFF, ON
Backlight brightness
LCD contrast
Bank switching
OFF (disabled)
KEY (enabled via the
front button control)
COM (enabled via
Modbus communica-
tion)
REQ input logic
ON
(request valid at ON)
OFF
(request valid at OFF)
DAV output logic
ON (data valid at ON)
OFF (data valid at
OFF)
DATA output logic
ON (negative logic
open collector)
OFF (positive logic
open collector)
Status output logic
ON (valid at ON)
OFF (valid at OFF)
Version indication
Indicating rmware
version
Measurement
stopped
+ for ≥ 3 sec.
or
Measurement
started
for ≥ 1 sec.
Advanced Setting Mode
Display refreshing
rate
0.0 – 99.9 sec.
Manual sub display
reset
OFF (automatically
reset)
ON (manually reset)
P output
OFF (no P output)
LL (alarm setpoint LL)
L (alarm setpoint L)
H (alarm setpoint H)
HH (alarm setpoint HH)
Latching alarm
OFF (no latching)
OUT (output latched /
measuring continued)
ALL (output latched /
measuring stopped)
Alarm power ON
delay
Standby sequence
OFF
(output immediately at
the startup)
ON
(output standing by
until the input enters
P zone)
Scaling error
ON (alarm trip action
valid at over-range)
OFF (no alarm trip
action at over-range)
Round off low-digit
readingtime
OFF, 2, 5, 10
Display reading type
NORMAL (measured
value)
MAX (MAX value)
MIN (MIN value)
47DAC OPERATING MANUAL EM-9518-B Rev.4
Event trigger mode
NORMAL (normal)
S-HLD (sampling hold)
P-HLD (peak hold)
B-HLD (valley (bottom)
hold)
PP-HLD (peak-to-peak
hold)
ON timing delay
OFF timing delay
Startup timer
Averaging type
MOVING (moving average)
SIMPLE (simple average)
Averaging time
OFF, 2, 4, 8, 16, 32, 64,
128, 256, 512
Low-end cutout
OFF (low-end cutout OFF)
ON (low-end cutout ON)
ABS (absolute value
low-end cutout ON)
Low-end cutout value
Display color
GRN-R (green (normal) to
red (alarm))
GRN (green)
RED-G (red (normal) to
green (alarm))
RED (red)
Automatic return time
to Measuring Mode
00 (automatic return
disabled)
1 – 99 sec.
Transition time to
Lockout Setting Mode
0 – 99 sec.
247