M-system 47DAC Operating Manual page 114

3
Press Shift or Up button to select the main display blinking at
alarm.
• Select one among '0' , '1' , '2' and '3' .
4
Press Alarm/↓ or Scale/↑ button to apply the new setting.
• And the next parameter setting is indicated.
NOTE
• Press Alarm/↓ button, and the alarm output pattern will be indicated (' A LM PTN' on the SD), or the bank copy will be
indicated ('BNK CPY' on the SD) with the bank switching set to "enabled via the front button control" .
• Press Scale/↑ button, and the HH setpoint will be indicated (' A LARMHH' on the SD), or the P coil at alarm will be indi-
cated ('RELAY P' on the SD) with the alarm setting lockout set to "completely unlock Alarm Setting Mode" .
5
Hold down Alarm/↓ or Scale/↑ button for 1 second or more to return to Measuring Mode.
47DAC OPERATING MANUAL EM-9518-B Rev.4
Blinking
114