Event Trigger Mode; Operating Procedure - M-system 47DAC Operating Manual

21.1 EVENT TRIGGER MODE

21.1.1 OPERATING PROCEDURE

1,3
1
Hold down Alarm/↓ and Scale/↑ buttons at once for 3 seconds
or more to move on to Advanced Setting Mode.
• The event trigger mode is indicated.
• The SD indicates 'EVENT' .
2
Press Shift and Up buttons to select the event trigger mode.
• Select one among 'NORMAL' , 'S-HLD' , 'P-HLD' , 'B-HLD' and 'PP-
HLD' .
3
Press Alarm/↓ or Scale/↑ button to apply the new setting.
• And the next parameter setting is indicated.
NOTE
• Press Alarm/↓ button, and the ON timing delay will be indicated ('ON-TDLY' on the SD), or the startup timer will be indi-
cated ('STR-TMR' on the SD) with the event trigger mode set to "normal" .
• Press Scale/↑ button, and the firmware version indication will be indicated ('FRM-VER' on the SD).
2
1,3 2
NOTE
The following figures are display examples. The displays
depend on the settings.
47DAC OPERATING MANUAL EM-9518-B Rev.4
Blinking
171