Install The Riser Cage - HPE ProLiant DL20 Gen10 User Manual

Install the riser cage

Install the riser cage
CAUTION: CAUTION:
To prevent damage to the server or expansion boards, power down the server, and disconnect all power cords before
removing or installing the riser cage.
Procedure Procedure
1. Connect all necessary internal cabling to the expansion board.
2. Install the riser cage. Make sure that the riser board is firmly seated in its system board connector.
3. Install the access panel .
4. Install the server into the rack .
5. Connect all peripheral cables to the server.
6. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
7. Power up the server .
8. If removed, install the front bezel .
Install the riser cage 45