Table of Contents
Advertisement
ICP DAS PMC-523x/PMC-224x/PMD Series User Manual
(b.) In the "Exception Date(s)" selection, click on "Add" to add the
(c.) In the "Time Range(s)" section, click "Add" to add new Time
iv Click on "OK" to confirm the setting and leave the setting page.
v
Repeat steps i~iv to complete settings of all Schedule.
vi To modify the settings of a pre-set Schedule, please click on the radio
button in front of the Schedule, and then click on "Setting" to modify
the settings.
vii To copy the settings of a pre-set Schedule to the new Schedule, please
click the radio button in front of the pre-set Schedule and then click
"Copy", a new Schedule (in sequence) will be added to the list and the
settings of the old Schedule will be copied to this newly added
Schedule.
viii To remove a pre-set Schedule, please click the radio button in front of
the pre-set Schedule and then click "Remove".
ix After all schedule settings are completed, click "Save" button to save
the changes.
date(s) that is/are not going to execute the schedule. Click
"Remove" to remove a pre-set Exception Date.
Range to execute this schedule. Select the start time and the end
time from the dropdown list. Each Schedule is required to set at
least one Time Range; click on "Add" to add more Time Range.
Please note: the time zones you specified can't be overlapped. If
you specify an end time that is earlier than the start time, such
as 20:00:00 ~ 06:00:00, it indicates the end time will be set one
day after the start date.
Time Range.
Click "Remove" to remove a pre-set
188
Advertisement
Table of Contents
